Skip to Content

How to track truck waiting time at warehouses

Record three timestamps for each visit: when the truck was due, when it joined the queue or checked in, and when the warehouse released it. GPS geofences help log arrival and departure consistently. The appointment record and gate log tell you what the GPS events mean. Without both, a depot can look fast on paper while your trucks spend half the morning outside.

Start with the waiting you can act on

What to measure Start and end Why it matters
Outside queue Queue arrival to gate-in Finds delay that an inside-the-gate report misses.
On-site dwell Gate-in to gate-out Shows how long vehicles are tied up on the premises.
Bay wait Gate-in to loading or unloading start Helps separate dock scheduling from handling time.

Where there is a designated staging area, configure it separately in VoltCred geofencing. If trucks queue on a public road, don't draw a wide boundary that includes unrelated traffic. Ask dispatch to corroborate queue arrival using the driver's check-in, gate token or trip record. Use the gate log for ambiguous GPS events and label missing timestamps rather than filling them in.

Worked example: two reports, one truck

Suppose a truck reaches the designated queue at 09:50 for a 10:00 appointment. It enters at 10:40 and leaves at 11:30.

  • Outside queue: 50 minutes, of which 10 were before the appointment.
  • On-site dwell: 50 minutes.
  • Total time tied up: 100 minutes from queue arrival to exit.

Those 100 minutes aren't automatically billable detention. Verify the agreed start event, any grace period and evidence requirements before making a claim. If the clock starts at verified gate-in and the agreement includes 60 free minutes, this illustrative visit has zero billable minutes under those assumptions. A fleet can still use the missing 50 minutes of gate-only visibility to improve planning, even when it can't invoice the delay.

Turn a week of visits into an operating decision

  1. Choose one warehouse and capture one full week of visits. Keep appointment, queue, gate-in and gate-out times side by side.
  2. Review the middle visit and the worst few, not just the average. Record visit counts alongside times and split by shift when you have enough visits.
  3. Assign one person to label the cause of each long wait: early arrival, gate queue, no bay, paperwork, or unknown.
  4. Act on one repeatable problem. For example, if delays cluster at shift change, test a different arrival slot and compare similar visits the following week. Keep unresolved visits out of billing calculations.

Talk to VoltCred about a one-site pilot. Share the type of site, fleet size and whether you can access gate timestamps.

Can you switch fleet GPS platforms without replacing your trackers?